Civil Technology Grade 10 Term 4 November Past Papers and Memos

1. Q1 Safety1.1 FIGURE 1.1 below shows a worker and a visitor on a construction site. 20 marks
2. Q2 Materials, Tools and Equipment2.1 Choose a description from COLUMN B that matches an item in COLUMN A. 40 marks
3. Q3 Graphics As Means of Communication3.1 Define the term CAD, as used in drawing. (1) 40 marks
4. Q4 Joining and Quantities4.1 Explain THREE advantages of using nails over screws. (3) 40 marks
5. Q5 Foundations, Concrete and Brickwork5.1 Identify the tools illustrated in FIGURE 5.1.1 and FIGURE 5.1.2 below. 30 marks
6. Q6 Formwork6.1 Name ONE type of nail thatm ay be us edto join the different members of 30 marks
7. Q7 Construction, Storm Water and Roof Work7.1 Explain THREE good lifting techniques that shoulbe d applied when lifting 30 marks
8. Q8 Hot- and Cold-Water Supply and Sanitary Fitments8.1 Name TWO properties of clean water. (2) 30 marks
9. Q9 Casements9.1 Draw a horizontal section through a tree trunk to show the following parts: 30 marks
10. Q10 Doors10.1 Predict ONE negative consequence of poor housekeeping. (1) 30 marks

Instructions to candidates

1. This question paper consists of FOUR sections: SECTIONS A, B, C and D.
2. SECTION A (QUESTIONS 1, 2, 3, and 4) is COMPULSORY for all learners.
3. Choose ONE of the following SECTIONS according to the area of specialisation that you have registered for: SECTION B (QUESTIONS 5 and 6) – Construction SECTION C (QUESTIONS 7 and 8) – Civil Services SECTION D (QUESTIONS 9 and 10) – Woodworking NOTE: If you ans
4. Number the answers correctly according to the numbering system used in this question paper.
5. Start the answer to EACH question on a NEW page.
6. Do NOT write in the margin of the ANSWER BOOK.
7. You may use sketches to illustrate your answers.
8. Write ALL calculations and answers in the ANSWER BOOK or on the attached ANSWER SHEETS. Answers to calculations should be rounded off to TWO decimal places. Show the units of ALL answers.
9. Use the mark allocation as a guide to the length of your answers.
10. Make drawings and sketches in pencil, fully dimensioned and neatly finished off with descriptive titles and notes to conform to the SANS/SABS Code of Practice for Building Drawings.
11. For the purpose of this question paper, the size of a brick should be taken as 220 mm x 110 mm x 75 mm.
12. Use your own discretion where dimensions and/or details have been omitted.
13. All dimensions are in millimetres, unless stated otherwise.
14. Answer QUESTIONS on the attached ANSWER SHEETS, as prescribed in each question where applicable.